K20 K24 K Series K Swap Conversion Wiring Harness for ECU | OBD2A 96-98 Honda Civic

OBD2A-KSUB-1

K20 K24 K Series K Swap Conversion Wiring Harness for ECU | OBD2A 96-98 Honda Civic

£98.88 £68.44
/
Shipping calculated at checkout.
  • Question? Call us at (888) 257-1077 🏁
  • info@10SecondRacing.com
  • Free Shipping to Lower 48 US States ($100+)
  • Worldwide Shipping via UPS (Check Rates at Checkout)

    • This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

    A K-swap conversion harness is a must-have part for any K-series engine swap. The harness is required to join up the factory K-series engine harness to the factory dash harness of the swapped car.  It is designed integrate the K-series ecu and all of the related electrical functions get them operating properly.  Functions like the fuel pump, tach, speedo, starter signal, O2 sensors, etc.

    Our harness harness is 99% plug and play and takes very little time to install.  The harness is constructed with quality mil-spec wire and finished with a nice clean looking mil-spec nylon sleeving for protection. No Instructions included.


     ***Professional Installation is recommended.

     The end result is a very high quality conversion harness at the best possible price.  Several applications are available so get yours to make sure your K-swap is wired up right!

     

    • This harness works with all USDM / JDM 02-04 wiring harnesses including, K20A, K20A2, K20A3.
    • This harness is wired to use the factory wideband O2 sensor so European customers using the UKDM K20A/K20A2 wiring harness will need to convert the harness to use the narrowband type sensor.
    • This harness does NOT work with any 05-06 OR K24 engine wiring harnesses.